Installing System Components 89
Figure 3-7. Removing and Installing a Power Supply
Installing a Power Supply
1
On a system with redundant power supplies, verify that both power
supplies are of the same type and have the same maximum output power.
NOTE: The maximum output power of the power supply (listed in watts) is
located near the center of the power supply label.
2
Slide the new power supply into the chassis until the power supply is fully
seated and the release latch snaps into place. See Figure 3-7.
NOTE: If you unlatched the cable management arm in step 2 of the previous
procedure, relatch it. For information about the cable management arm, see
the system’s rack documentation.
3
Connect the power cable to the power supply and plug the cable into a
power outlet.
1 power-supply handle 2 Velcro strap
3 release latch
book.book Page 89 Tuesday, September 15, 2009 10:08 AM
To Next Page
Loading...
