Dell PowerEdge T610 - Installing a Hard-Drive Blank; Removing a Hot-Swap Hard Drive

84 Installing System Components
Figure 3-4. Removing and Installing a Hard Drive Blank
Installing a Hard-Drive Blank
Align the hard-drive blank with the drive bay and insert the blank into the
drive bay until the release lever clicks into place.
Removing a Hot-Swap Hard Drive
CAUTION: To prevent data loss, ensure that your operating system supports hot-
swap drive removal and installation. See the documentation provided with your
operating system for more information.
1 Remove the front bezel. See "Removing the Front Bezel ."
2 From the RAID management software, prepare the drive for removal. Wait
until the hard-drive indicators on the hard-drive carrier signal that the
drive can be removed safely.
See your controller documentation for
information about hot-swap drive removal.
1 3.5-in hard drive blank 2 2.5-in hard drive blank
3 release latch
3
1
2
3
book.book Page 84 Tuesday, September 15, 2009 10:08 AM