Dell PowerEdge - NVMe PCIe SSD Firmware Update Issues; NVMe PCIe SSD Driver Installation Failures; NVMe PCIe SSD Not Found During OS Install; Cryptographic Erase Failures

Cannot update NVMe PCIe SSD rmware by using Dell Update
Package or DUP
Likely Cause: The supported device driver for the operating system on your system is not installed.
Corrective Action: Before you update the NVMe PCIe SSD rmware using DUP, ensure that the required device driver for the
operating system available on your system is installed.
Third-party driver installation for NVMe PCIe SSD failing
Description: While NVMe mode is set to RAID and operating system installation is complete, installing a third-party driver for
NVMe PCIe SSD may fail.
Solution Third-party drivers for NVMe PCIe SSDs are not supported with NVMe in RAID mode.
Unable to nd the NVMe PCIe SSD for operating system
installation
Likely Cause:
S140 drivers are installed while SATA is in non-RAID mode.
Corrective Action: Ensure that SATA is in RAID mode before installing S140 driver.
Cryptographic erase fails for ISE-capable SATA drives
Description
An error message, Cryptographic erase failed, is displayed while performing a cryptographic erase, on an ISE-
capable SATA drive. The error message may appear if the cryptographic erase takes longer than expected, even
though the erase operation is complete.
Solution Wait for two minutes and then click OK to complete the cryptographic erase.
Virtual disks - Related errors
Cannot create a virtual disk
If you are unable to create a virtual disk, check the following causes:
1 The physical disk is not displayed.
2 Insucient free space available on the selected physical disks.
3 Incorrect number of physical disks selected for the desired RAID level .
4 The desired physical disk is unavailable.
5 The system already has a maximum of 16 virtual disks.
50
Troubleshooting your system