Dell PowerStore 500T - Remove the embedded module cover from the node; Remove a 4-port card

Figure 17. Removing the node
6. Place the node on a clean, flat, static-free work surface.
Remove the embedded module cover from the node
Steps
1. While pushing down the blue release buttons, slide the top cover towards the rear of the system until it stops.
2. Lift the top cover upward, and remove it from the node.
Figure 18. Removing the embedded module cover
Remove a 4-port card
Steps
1. Remove the SFPs from the front of the embedded module.
2. Push down the two blue tabs on the back of the 4-port card to release the 4-port card.
22
Base enclosure service procedures