NOTE: The leftmost DIMM slot is 11, and the slots decrease sequentially to slot 0 on the far right.
2. Depress the white or black retaining tabs downward to free the DIMM from its slot.
3. Remove the faulted DIMM.
Figure 48. Removing the DIMM
Install the dual inline memory module
Steps
1. Touching only the outside edges of the DIMM, align the DIMM with the connector.
2. Press the DIMM vertically down into the socket using pressure at each end while keeping the leading edge of the DIMM
parallel to the connector until it fully seats to the bottom of the socket. When the DIMM engages the contacts in the socket,
you will feel resistance, and slightly more force is required to push the module down. During this stage, keep in mind the
following precautions:
● Do not insert the DIMM at an angle.
● Do not rock the DIMM.
● Do not insert the DIMM by pushing on one end.
● Do not seat one end of the DIMM and then the other.
Figure 49. Installing the DIMM
3. Proper DIMM insertion will automatically close the latch ejectors and lock the DIMM into the socket. Verify that the latch
ejectors are fully closed and have engaged the notches in the DIMM.
Install the top cover on the node
Steps
1. Position the top cover over the node and align it with the slots in the sides at the rear of the node.
2. Pull the top cover forward to secure it in place.
42
Base enclosure service procedures
To Next Page
Loading...
