Dell PowerStore 500T - Remove the faulted internal M.2 boot module

Figure 56. Removing the top cover
Remove the faulted internal M.2 boot module
Steps
1. Gently pull straight up on the blue pull tab to release the internal M.2 boot module from the motherboard.
Figure 57. Releasing the internal M.2 boot module from the motherboard
2. Touching only the outside edges of the internal M.2 boot module, lift the end of the internal M.2 boot module to a slight
angle, and then remove it from the slot on the motherboard.
Figure 58. Removing the internal M.2 boot module
48
Base enclosure service procedures