Dell PowerStore 500T - Remove a faulted I;O module; Install a new I;O module

Remove a faulted I/O module
Steps
1. Pull the trigger mechanism on the I/O module handle to release it.
CAUTION: Do not pull the node from the base enclosure.
Figure 29. Releasing the I/O module
2. Gently pull the I/O module from the slot.
Figure 30. Removing the I/O module
Install a new I/O module
Steps
1. Align the module with the empty slot and carefully push the module into the slot.
Figure 31. Installing an I/O module
2. When the I/O module appears seated, push and release the small button on the handle.
● If the button remains in, the module is fully seated.
30
Base enclosure service procedures