Management: Installing Array Components 219
3
Remove the hard drives from:
– slots 0 to 2 in
PowerVault MD3200
– slots 0 to 5 in
PowerVault MD3220
See "Removing a Hard Drive" on page 204.
NOTE: Mark each hard drive with it’s slot position as you remove it.
4
Slide the control panel out of the chassis after:
– Pushing the release tab toward the front of the array in
PowerVault
MD3200
. See Figure 15-13.
– Pulling the release pin toward the front of the array in
PowerVault
MD3220
. See Figure 15-14.
Figure 15-13. Removing and Installing the Control Panel-PowerVault MD3200
1 control panel 2 release tab
book.book Page 219 Tuesday, September 27, 2011 3:25 PM
To Next Page
Loading...
