Dell PowerVault MD3200 - Installing the Backplane

224 Management: Installing Array Components
Installing the Backplane
1 Align the holes on the backplane with the holes on the array.
2 Tighten the captive screw to secure the backplane to the chassis.
See Figure 15-16 for PowerVault MD3200 or Figure 15-17 for
PowerVault MD3220.
3 Replace the screws that secure the backplane to the chassis.
See Figure 15-16 for PowerVault MD3200 or Figure 15-17 for
PowerVault MD3220.
4 Align the slots on the RAID controller module/power supply cage with the
tabs on the chassis. See Figure 15-15.
5 Push the RAID controller module/power supply cage toward the front of
the array.
6 Replace the screws that secure the RAID controller module/power supply
cage to the chassis.
7 Replace the control panel. See "Installing the Control Panel" on page 220.
8 Replace the power supply/cooling fan modules. See "Installing a Power
Supply/Cooling Fan Module" on page 217.
9 Replace the hard drives. See "Installing a Hard Drive" on page 206.
10 Connect all the cables to the array.
11 Turn on the array and the host server.
book.book Page 224 Tuesday, September 27, 2011 3:25 PM