Troubleshooting: Your Storage Array Software 239
Finding Nodes
You can use the Find option to search for a particular node on the Logical tab,
the Physical tab, or the Mappings tab of the AMW. The search may be based
on a particular node name, the RAID level, virtual disk capacity, or specific
free capacity nodes. The search may be based also on one of these
combinations:
• The node name and the RAID level
• The node name and the virtual disk capacity
To find nodes:
1
In the AMW, select
View
Find
.
2
Based on the type of search, select one of these options, and go to the
indicated step:
• Search by name – see step 3.
• Search by special criteria – see step 4.
3
Type the name of the node to be found in
Find Node
. See step 8.
4
Based on the search criteria, select one of these options, and go to the
indicated step:
• Find all virtual disks with RAID level—Go to step 5.
• Find all virtual disks with capacity—Go to step 6.
• Find all free capacity nodes—Go to step 7.
5
To search for all nodes based on their RAID level, perform these steps:
a
Select
Find all virtual disks with RAID level
.
b
Select the RAID level from the list.
c
Go to step 8.
book.book Page 239 Tuesday, September 27, 2011 3:25 PM
To Next Page
Loading...
