Dell PowerVault MD3200 - Installing the Control Panel

220 Management: Installing Array Components
Figure 15-14. Removing and Installing the Control Panel-PowerVault MD3220
Installing the Control Panel
1 Align the control panel with the slot on the array.
2 Slide the control panel into the array until:
– The release tab clicks into place in
PowerVault MD3200 .
See Figure 15-13.
– The release pin clicks into place in
PowerVault MD3220 .
See Figure 15-14.
3 Replace the hard drives in their respective slots. See "Installing a Hard
Drive" on page 206.
4 Connect all the power cables to the array.
5 Turn on the array and the host server.
1 control panel 2 release pin
2
1
book.book Page 220 Tuesday, September 27, 2011 3:25 PM