Management: Installing Array Components 199
Removing a RAID Controller Module
CAUTION: Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1
Disconnect the cables connected to the RAID controller module.
2
Push down on the release tab and pull the release lever away from the
chassis. See Figure 15-8.
3
Grasp the release lever and pull the module away from the chassis.
NOTE: To avoid damage to the sensitive EMI contacts on the RAID controller
module, do not stack RAID controller module s.
Figure 15-8. Removing and Installing a RAID controller module
1 RAID controller module 2 release tab
3 release lever
book.book Page 199 Monday, June 21, 2010 11:00 AM
To Next Page
Loading...
