Configuration: About Your Host 89
• Changing a host type
MDSM automatically detects these changes for any host running the host
agent software.
Starting or Stopping the Host Context Agent
The host context agent discovers the host topology. The host context agent
starts and stops with the host. The topology discovered by the host context
agent can be viewed by clicking Configure Host Access (Automatic) in the
Configure tab in the MDSM.
You must stop and restart the host context agent to see the changes to the
host topology if:
• A new storage array is attached to the host server.
• A host is added while turning on power to the RAID controller modules.
Linux
To start or stop the host context agent, enter the following command at the
prompt:
SMagent start
SMagent stop
You stop and then restart SMagent after:
• Moving a controller offline or replacing a controller.
• Removing host-to-array connections from or attaching host-to-array
connections to a Linux host server.
Windows
To start or stop the host context agent:
1
Click
Start
Settings
Control Pane
l Administrative Tools
Services
.
or
Click
Start
Administrative Tools
Services
.
2
From the list of services, select
Modular Disk Storage Manager Agent
.
book.book Page 89 Monday, June 21, 2010 11:00 AM
To Next Page
Loading...
