Dell PowerVault ML6000 User Manual

v Keystore
v Dell Encryption Key Manager
Library-Managed Tape Encryption Tasks
1. Install and cable the LTO 4 and LTO 5 Tape Drive(s).
v Update library firmware (TL2000, TL4000, ML6000 where necessary). Visit
http://support.dell.com.
– Dell
™
PowerVault
™
TL2000 Tape Library minimum required firmware
version = 5.xx.
– Dell
™
PowerVault
™
TL4000 Tape Library minimum required firmware
version = 5.xx.
– Dell
™
PowerVault
™
ML6000 Tape Library Family minimum required
firmware version = 415G.xxx.
v Update tape drive firmware if necessary The minimum required firmware
version is 77B5.
2. Enable LTO 4 and LTO 5 Tape Drives and Tape Library for library-managed
tape encryption (see your Dell tape library information for details).
v Add Encryption Key Manager Server IP addresses
3. Use library diagnostic functions to verify Encryption Key Manager paths and
encryption configuration (see your Dell tape library information for details).
Hardware and Software Requirements
Note: Only the IBM version of the Java Runtime Environment (JRE) for each of the
following platforms supports the Encryption Key Manager.
Linux Solution Components
Operating Systems
v RHEL 4
v RHEL 5
v SLES 9
v SLES 10
v SLES 11
Encryption Key Manager (Running on Linux)
Table 2-1. Minimum Software Requirements for Linux
Platform
IBM Software
Developer Kit Available at:
64-bit AMD/Opteron/
EM64T
Java 6.0 SR5 http://support.dell.com
32-bit Intel
®
compatible
Tape Libraries
For the Dell PowerVault TL2000 Tape Library, TL4000 Tape Library, and ML6000
Tape Library, assure that the firmware level is the latest available. For firmware
updates, visit http://support.dell.com.
2-2 Dell Encryption Key Mgr User's Guide
|
|
|
|
|
|
|

Dell PowerVault ML6000 Specifications

General

Brand	Dell
Model	PowerVault ML6000
Category	Storage
Language	English