Installing front input and output panel
1. Insert the input and output(I/O) panel onto its slot in the system.
2. Slide the panel to secure the hooks into the chassis hole.
3. Tighten the screw to secure the front I/O panel to the chassis.
4. Connect the following cables:
● intrusion switch cable
● USB 3.1 cable
● front I/O power cable
● front I/O power cable
● USB 3.1 cable
● speaker cable
● audio cable
5. Install the:
a. front input and output bezel
b. 5.25 inch ODD bracket
c. front bezel
d. side cover
Removing and installing components
45
To Next Page
Loading...
