Figure 34. Removing and installing the Network Daughter Card (NDC)
1. captive screw socket (2) 2. connector on the system board
3. captive screw (2) 4. touch point (2)
5. network daughter card 6. back panel slot for Ethernet connectors
1. Replace the network daughter card.
2. Follow the procedure listed in After working inside your system.
To see a video on how to remove & install the network daughter card, scan this QR code, or click here:
http://www.Dell.com/QRL/Workstation/R7910/NDC
73
To Next Page
Loading...
