Clearing CMOS Settings
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the Cover.
3. Locate the 3-pin CMOS jumper (CLEAR CMOS) on the system board.
4. Remove the jumper plug from the CMOS jumper (CLEAR CMOS) pins 2 and 3.
5. Place the jumper plug on the CMOS jumper (CLEAR CMOS) pins 1 and 2 and wait approximately five seconds.
6. Remove the jumper plug and replace it on the CMOS jumper (CLEAR CMOS) pins 2 and 3.
7. Replace the Cover.
Back to Contents Page
To Next Page
Loading...
