47 Dell EMC Networking with Isilon Front-End Deployment and Best Practices Guide | version 1.0
Note: Refer to Isilon Network Design Considerations for more information on specific protocols as they
relate to OneFS.
interface range ethernet 1/1/53-1/1/54
decription VLTi
no switchport
no shutdown
vlt-domain 127
backup destination 100.67.170.14
discovery-interface ethernet 1/1/53-1/1/54
interface range ethernet 1/1/53-1/1/54
description VLTi
no switchport
no shutdown
vlt-domain 127
backup destination 100.67.170.15
discovery-interface ethernet 1/1/53-1/1/54
Next, we will create the VLANs. IP addresses and VRRP is configured at the spine layer. On each leaf
switch, the respective VLAN will be defined without an IP address or VRRP.
interface vlan100
no shutdown
interface vlan100
no shutdown
Configure the downstream port channels. There will be one port channel for each server as well as a single
port channel for each of the Isilon nodes. Each port channel is assigned an MTU of 9216 to support jumbo
frames, as well configured to allow access to VLAN 100. The vlt-port-channel # command enables
port channels on VLT peers to function as a single port channel.
To Next Page
Loading...
Need help?
General
