Dell S3048-ON Deployment Guide

54 Dell EMC Networking with Isilon Front-End Deployment and Best Practices Guide | version 1.0
S4048-ON Leaf 3
S4048-ON Leaf 4
interface tengigabitethernet 1/1
description “Isilon Node 4-10gige-1”
no shutdown
port-channel-protocol LACP
port-channel 1 mode active
mtu 9216
flowcontrol rx on tx off
interface tengigabitethernet 1/3
description “Isilon Node 5-10gige-1”
no shutdown
port-channel-protocol LACP
port-channel 3 mode active
mtu 9216
flowcontrol rx on tx off
interface tengigabitethernet 1/5
description “Isilon Node 6-10gige-1”
no shutdown
port-channel-protocol LACP
port-channel 5 mode active
mtu 9216
flowcontrol rx on tx off
interface tengigabitethernet 1/17
description “Server 3-1”
no shutdown
port-channel-protocol LACP
port-channel 101 mode active
mtu 9216
flowcontrol rx on tx off
interface tengigabitethernet 1/19
description “Server 4-1”
no shutdown
port-channel-protocol LACP
port-channel 102 mode active
mtu 9216
flowcontrol rx on tx off
interface tengigabitethernet 1/1
description “Isilon Node 4-10gige-2”
no shutdown
port-channel-protocol LACP
port-channel 1 mode active
mtu 9216
flowcontrol rx on tx off
interface tengigabitethernet 1/3
description “Isilon Node 5-10gige-2”
no shutdown
port-channel-protocol LACP
port-channel 3 mode active
mtu 9216
flowcontrol rx on tx off
interface tengigabitethernet 1/5
description “Isilon Node 6-10gige-2”
no shutdown
port-channel-protocol LACP
port-channel 5 mode active
mtu 9216
flowcontrol rx on tx off
interface tengigabitethernet 1/17
description “Server 3-2”
no shutdown
port-channel-protocol LACP
port-channel 101 mode active
mtu 9216
flowcontrol rx on tx off
interface tengigabitethernet 1/19
description “Server 4-2”
no shutdown
port-channel-protocol LACP
port-channel 102 mode active
mtu 9216
flowcontrol rx on tx off
Configure the necessary downstream port channels. There will be one port channel for each server as well as
a single port channel for each of the Isilon nodes. Each port channel is assigned an MTU of 9216 to support
jumbo frames. The vlt-peer-lag-port-channel # command ensures that each switch in the VLT is
aware of all port channels and can act accordingly in the event of a switch failure.

Dell S3048-ON Specifications

General

Rack Units	1U
Form Factor	Rack-mountable
Input Voltage	100-240V AC
Power Supply	2 hot-swappable power supplies
Management	CLI, Web, SNMP
Product Type	Switch
MAC Address Table Size	32K entries
Jumbo Frame Support	Yes
Latency	< 3 microseconds
Ports	48 x 1GbE RJ45, 4 x 10GbE SFP+