Worksheet to Record System Information
Use the following worksheet to record the information that is needed to install the SCv2000/SCv2020
storage system
.
Storage Center Information
Gather and record the following information about the Storage Center network and the administrator
user.
Table 1. Storage Center Network
Service Tag ________________
Management IPv4 address (Storage Center management address) ___ . ___ . ___ . ___
Top Controller IPv4 address (Controller 1 MGMT port) ___ . ___ . ___ . ___
Bottom Controller IPv4 address (Controller 2 MGMT port) ___ . ___ . ___ . ___
Subnet mask ___ . ___ . ___ . ___
Gateway IPv4 address ___ . ___ . ___ . ___
Domain name ________________
DNS server address ___ . ___ . ___ . ___
Secondary DNS server address ___ . ___ . ___ . ___
Table 2. Storage Center Administrator
Password for the default Storage Center “Admin” user ________________
Email address of the default Storage Center “Admin” user ________________
iSCSI Fault Domain Information
For a storage system with iSCSI front-end ports, gather and record network information for the iSCSI fault
domains. This information is needed to complete the Discover and Configure Uninitialized SCv2000
Series Storage Centers wizard.
NOTE: For a storage system deployed with two Ethernet switches, Dell recommends setting up
each fault domain on separate subnets.
See the Dell Storage Center SCv2000/SCv2020 Storage System Deployment Guide for information about
setting up iSCSI fault domains.
Table 3. iSCSI Fault Domain 1
Target IPv4 address ___ . ___ . ___ . ___
Subnet mask ___ . ___ . ___ . ___
Gateway IPv4 address ___ . ___ . ___ . ___
5
To Next Page
Loading...
Need help?
General
