28 | Setting Up the Monitor
Connecting the DisplayPort (DP to DP) cable
NOTE: The default out of factory setting in the U3818DW is DP1.2. If the monitor
fails to show any content after the DP cable is connected, follow the procedures
below to change the settings from DP1.2 to DP1.1:
• Press second button next to the button to activate the OSD menu.
• Use the
and buttons to highlight Input Source, then use the button
enter the submenu.
• Use the
and buttons to highlight DP.
• Pr
ess and hold the button for approximately 10 seconds, and the DP
configuration message appears.
• Use the
button to select Disable and change the settings.
Repeat the above steps to change the DP format settings if necessary.
Connecting the USB Type-C cable
To Next Page
Loading...
