Installing the Coin-Cell Battery
1. Push the coin-call battery into its slot on the system board.
2. Install the access panel.
3. Follow the procedures in
After Working Inside Your Computer
.
Removing the Memory
1. Follow the procedures in
Before Working Inside Your Computer
.
2. Remove the access panel.
3. Use your fingertips to spread apart the securing clips on each end of the memory module connector until the
memory module pops up and remove the memory module from its connector on the system board by drawing the
module from the system board at 45-degree angle.
Installing the Memory
1. Insert and secure the memory module to the system board.
2. Install the access panel.
3. Follow the procedures in
After Working Inside Your Computer
.
Removing the Keyboard
1. Follow the procedures in
Before Working Inside Your Computer
.
2. Remove the screw that secures the keyboard to the chassis.
12
To Next Page
