Next steps
1. Replace the base cover
2. Replace the optical drive assembly
3. Replace the SD memory card
4. Follow the procedure in after working inside your computer
Memory modules
Removing the memory module
Prerequisites
1. Follow the procedure in before working inside your computer
2. Remove the SD memory card
3. Remove the optical drive assembly
4. Remove the base cover
5. Disconnect the battery cable from the connector on the system board.
Steps
1. Pry the clips securing the memory module until the memory module pops-up [1].
2. Remove the memory module from the memory module slot [2].
20
Removing and installing components
To Next Page
Loading...
