Icon Description Condition Corrective action
Hard drive
indicator
The indicator turns solid amber if
there is a hard drive error.
Check the System Event Log to determine if the drive
has an error. If the problem persists, see Support.
Temperature
indicator
The indicator turns solid amber if
the VxRail experiences a thermal
error (for example, the ambient
temperature is out of range or there
is a fan failure).
Ensure that none of the following conditions exist:
● A cooling fan has been removed or has failed.
● VxRail cover, air shroud, memory module blank, or
back filler bracket is removed.
● Ambient temperature is too high.
● External airflow is obstructed.
If the problem persists, see Support.
Electrical
indicator
The indicator turns solid amber if the
VxRail experiences an electrical error
(for example, voltage out of range, or
a failed power supply unit (PSU) or
voltage regulator).
Check the System Event Log or VxRail messages for
the specific issue. If it is due to a problem with the
PSU, check the LED on the PSU. Reseat the PSU. If
the problem persists, see Support.
Memory
indicator
The indicator turns solid amber if a
memory error occurs.
See the Support section.
PCIe indicator The indicator turns solid amber if a
PCIe card experiences an error.
See the Support section.
NOTE: For more information about the supported
PCIe cards, see Expansion card installation
guidelines.
VxRail health and VxRail ID indicator codes
The VxRail health and VxRail ID indicator is located on the left control panel of your VxRail.
The following table describes the health and ID indicator codes:
VxRail health and VxRail ID
indicator code
Condition
Solid blue Indicates that the VxRail is switched on, it is healthy, and VxRail ID mode is not
active. Press the VxRail health and VxRail ID button to switch to VxRail ID mode.
Blinking blue Indicates that the VxRail ID mode is active. Press the VxRail health and VxRail ID
button to switch to VxRail health mode.
Solid amber Indicates that the VxRail is in fail-safe mode. If the problem persists, see Support.
Blinking amber Indicates that the VxRail is experiencing a fault. If the problem persists, see Support.
Right control panel view
The following figure and table describes the features available on the right control panel:
12
VxRail overview
To Next Page
Loading...
