● Four RJ-45 ports that support 100 M, 1 G, and 10 Gbps
● Four SFP+ ports that support up to 10 Gbps
NOTE: You can install additional PCIe NIC cards. For more information on the PCIe NIC cards, see Expansion card
installation guidelines.
VGA ports
The Video Graphic Array (VGA) port enables you to connect the VxRail to a VGA display.
The VxRail P570, P570F, V570, V570F, and S570 supports two 15-pin VGA ports on the front and back panels.
Serial connector
The VxRail P570, P570F, V570, V570F, and S570 supports one serial connector on the back panel, which is a 9-pin connector,
Data Terminal Equipment (DTE), 16550-compliant.
Internal Dual SD Module
The VxRail P570, P570F, V570, V570F, and S570 support Internal Dual SD module (IDSDM).
The IDSDM is located at the back of the VxRail, in a Dell-proprietary slot. IDSDM card supports two micro SD cards. Micro SD
cards capacity for IDSDM are 64 GB.
NOTE:
The IDSDM on the VxRail is pre-configured for appliance bare metal recovery. It is not recommended to change any
of the settings.
Video specifications
The VxRail P570, P570F, V570, V570F, and S570 supports integrated Matrox G200eW3 graphics controller with 16 MB of video
frame buffer.
The following table describes the supported video resolution options:
Resolution
Refresh rate (Hz) Color depth (bits)
1024 x 768 60 8, 16, 32
1280 x 800 60 8, 16, 32
1280 x 1024 60 8, 16, 32
1360 x 768 60 8, 16, 32
1440 x 900 60 8, 16, 32
1600 x 900 60 8, 16, 32
1600 x 1200 60 8, 16, 32
1680 x 1050 60 8, 16, 32
1920 x 1080 60 8, 16, 32
1920 x 1200 60 8, 16, 32
NOTE: 1920 x 1080 and 1920 x 1200 resolutions are only supported in reduced blanking mode.
Environmental specifications
The following table describes the temperature specifications:
Technical specifications
23
To Next Page
Loading...
