Ite
m
Indicator, button, or
connector
Icon Description
1 Power button Indicates if the VxRail is turned on or off. Press the power button to manually
turn on or off the VxRail.
Press the power button to gracefully shut down an ACPI-compliant operating
system.
2 USB port (2) The USB ports are 4-pin, 2.0-compliant. These ports enable you to connect
USB devices to the VxRail.
3 iDRAC Direct port The iDRAC Direct port is micro USB 2.0-compliant. This port enables you
to access the iDRAC Direct features. For more information, see the iDRAC
Userâs Guide at Dell.com/idracmanuals.
4 iDRAC Direct LED N/A The iDRAC Direct LED indicator lights up to indicate that the iDRAC Direct
port is connected. For more information, see iDRAC Direct LED indicator
codes.
5 VGA port Enables you to connect a display device to the VxRail. For more information,
see Technical specifications.
iDRAC Direct LED indicator codes
The iDRAC Direct LED indicator lights up to indicate that the port is connected and is being used as a part of the iDRAC
subsystem.
iDRAC Direct LED indicator is located below the iDRAC Direct port on the right control panel. You can configure iDRAC Direct
by using a USB to micro USB (type AB) cable, which you can connect to your laptop or tablet.
The following table describes iDRAC Direct LED indicator codes and the related condition:
iDRAC Direct LED indicator code
Condition
Solid green for two seconds Indicates that the laptop or tablet is connected.
Flashing green (on for two seconds and off for two
seconds)î
Indicates that the laptop or tablet connected is recognized.
Turns off Indicates that the laptop or tablet is unplugged.
Rear view of the VxRail
The rear view displays the features available on the back of the VxRail.
The following figure and table describes the features available on the rear view of VxRail S570 with 2 x 3.5-inch drive:
VxRail overview
13
To Next Page
Loading...
