Dell W19B - Replacing the Rubber Feet; Procedure; Post-Requisites

Replacing the rubber feet
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in Before
working inside your computer. After working inside your computer, follow
the instructions in After working inside your computer. For more safety best
practices, see the Regulatory Compliance home page at
www.dell.com/
regulatory_compliance.
Procedure
1 Align the screw holes on the rubber feet with the screw holes on the display-
assembly base.
2 Replace the four screws (M3x5 black) that secure the rubber feet to the display-
assembly base.
Post-requisites
1 Replace the back cover.
2 Replace the stand.
86