Replacing the display assembly
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
1 Slide the palm-rest assembly under the hinges of the display assembly.
2 Using the alignment posts, press the display hinges down on the palm-rest assembly, aligning the screw holes on the display hinges
with the screw holes on the palm-rest assembly.
3 Connect the antenna cables to the system board.
The following table provides the antenna cable color schemes for the wireless card supported by your computer.
Table 2. Antenna-cable color scheme
Connectors on the wireless card Antenna-cable color
Main (white triangle) White
Auxiliary (black triangle) Black
19
34 Replacing the display assembly
To Next Page
Loading...
