Replacing the headset port
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Procedure
1 Place the headset port in its slot on the palm-rest assembly.
2 Replace the screw (M1.6x3) that secures the headset port to the palm-rest assembly
3 Reconnect the headset-port cable to the system board.
4 Using the alignment posts, press the right display hinge down to the palm-rest assembly aligning the screw holes on the display hinge
to the screw holes on the palm-rest assembly.
5 Replace the two screws (M2.5x4) that secure the left hinge to the palm-rest assembly.
21
38 Replacing the headset port
To Next Page
Loading...
