Removing the fans
WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your computer. After working inside your computer, follow the instructions in After working inside
your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Prerequisites
Remove the base cover.
Procedure
1 Remove the screw (M1.6x3) that secures the wireless antenna and camera cable bracket to the system board.
2 Lift the wireless antenna and camera cable bracket from the system board.
3 Disconnect and lift the camera cable from the system board, peeling o the tape securing the camera cable to the fans.
4 Disconnect the right fan cable from the system board.
5 Disconnect the left fan cable from the system board.
6 Remove the two screws (M1.6x3) that secure the left and right fan to the system board.
7 Lift the left and right fans along with their cables o the system board.
22
40 Removing the fans
To Next Page
Loading...
