4 Replace the four screws (M2.5x4) securing the display hinges to the palm-rest assembly and connect the camera cable to the system
board, adhering the tape securing the camera cable to the fans.
5 Align the screw hole on the wireless antenna and camera cable bracket to screw hole on the system board.
6 Replace the screw (M1.6x3) that secures the wireless antenna and camera cable bracket to the system board.
7 Connect the display cable to the system board.
8 Align the screw holes on the display-cable bracket with the screw holes on the system board.
9 Replace the two screws (M1.6x2.5) that secure the display-cable bracket to system board.
Post-requisites
Replace the base cover.
Replacing the display assembly
35
To Next Page
Loading...
