48 Power-Button Board
10
Remove the two screws that secure the power-button board to the
palm-rest assembly.
11
Lift the power-button board off the palm-rest assembly.
Replacing the Power-Button Board
1
Follow the instructions in "Before You Begin" on page 9.
2
Use the alignment post to place the power-button board on the palm-rest
assembly.
3
Replace the two screws that secure the power-button board to the
palm-rest assembly.
4
Slide the power-button board cable into the connector on the
power-button board and press down on the connector latch to secure the
cable.
5
Replace the palm-rest assembly (see "Replacing the Palm-Rest Assembly"
on page 40).
6
Replace the optical drive (see "Replacing the Optical Drive" on page 34).
1 screws (2) 2 palm-rest assembly
3 power-button board 4 power-button board cable connector