Internal Card With Bluetooth
®
Wireless Technology 55
12
Internal Card With Bluetooth
®
Wireless Technology
WARNING: Before working inside your computer, read the safety information
that shipped with your computer. For additional safety best practices information,
see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your
computer. Damage due to servicing that is not authorized by Dell™ is not covered
by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface (such as a
connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery
(see "Removing the Battery" on page 13) before working inside the computer.
Removing the Bluetooth Card
1
Follow the instructions in "Before You Begin" on page 9.
2
Remove the battery (see "Removing the Battery" on page 13).
3
Remove the module cover (see "Removing the Module Cover" on
page 15).
4
Remove the memory module(s) (see "Removing the Memory Module(s)"
on page 17).
5
Follow the instructions in step 5 in "Removing the Hard Drive(s)" on
page 27.
6
Remove the optical drive (see "Removing the Optical Drive" on page 33).
7
Remove the palm-rest assembly (see "Removing the Palm-Rest Assembly"
on page 37).
8
Disconnect the Bluetooth-card cable from the system-board connector.
9
Lift the Bluetooth card along with the cable off the computer base.