Using Multimedia 57
FILE LOCATION: S:\systems\Thurman\OM\A00\New Folder\Webworks\source\media.fm
DELL CONFIDENTIAL – PRELIMINARY 6/12/07 - FOR PROOF ONLY
If you want to connect your computer to a TV or audio device, it is
recommended that you connect video and audio cables to your computer in
one of the following combinations:
• S-video and standard audio
• Composite video and standard audio
• Component-out video and standard audio
NOTE: See the diagrams at the beginning of each subsection to help you determine
which method of connection you should use.
When you finish connecting the video and audio cables between your
computer and your TV, you must enable your computer to work with the TV.
See "Enabling the Display Settings for a TV" on page 58 to ensure that the
computer recognizes and works properly with the TV. Additionally, if you are
using S/PDIF digital audio, see "Enabling the Display Settings for a TV" on
page 58.
HDMI
HDMI (High-Definition Multimedia Interface) connector carries an
uncompressed all digital signal to produce hi-defination video and audio.
1
Turn off the computer and the TV and/or audio device that you want to
connect.
2
Plug one end of the HDMI cable into the HDMI output connector on the
computer.
3
Plug the other end of the HDMI cable into the HDMI input connector on
your TV.
4
Plug the single-connector end of the audio cable into the headphone
connector on your computer.
5
Plug the two RCA connectors on the other end of the audio cable into the
audio input connectors on your TV or other audio device.
6
Turn on the TV and any audio device that you connected (if applicable),
and then turn on the computer.
7
See "Enabling the Display Settings for a TV" on page 58 to ensure that the
computer recognizes and works properly with the TV.
8
Turn on the TV, turn on any audio device that you connected (if
applicable), and then turn on the computer.
To Next Page
Loading...
Need help?
General
