15
Cleaning the inside of the coee machine
Danger of electric shock!
Before cleaning internal parts, the machine must be turned o
(see “Turning o”) and unplugged from the mains power sup-
ply. Never immerse the machine in water.
1. Check regularly (about once a week) that the inside of the
appliance (accessible after removing the drip tray) is not
dirty. If necessary, remove coee deposits with a sponge.
2. Remove the residues with a vacuum cleaner (g. 25).
Cleaning the water tank
1. Clean the water tank (A9) regularly (about once a month)
and whenever you replace the water softener lter (if
provided) with a damp cloth and a little mild washing up
liquid.
2. Remove the lter (if present) and rinse with running water.
3. Replace the lter (if provided), ll the tank with fresh
water and replace the tank.
Cleaning the coee spouts
1. Clean the coee spouts with a sponge or cloth (g. 26A).
2. Check the holes in the coee spout are not blocked. If nec-
essary, remove coee deposits with a toothpick (g. 26B).
Cleaning the pre-ground coee funnel
Check regularly (about once a month ) that the pre-ground cof-
fee funnel is not blocked. If necessary, remove coee deposits.
Cleaning the infuser
The infuser (A11) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned o (see “Turning
o”, page 10).
2. Remove the water tank.
3. Open the infuser door (g. 27) on the right side of the
appliance.
4. Press the two red release buttons inwards and at the same
time pull the infuser outwards (g. 28).
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID NO DISH WASHER
Clean the infuser without using washing up liquid as it
could be damaged.
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap.
6. Clean coee residues from the support where the infuser
rests.
7. After cleaning, replace the infuser by sliding it onto the
internal support, then push the PUSH symbol fully in until
it clicks into place.
Please note :
If the infuser is dicult to insert, before insertion, adapt it to the
right size by pressing the two levers shown in the gure.
8. Once inserted, make sure the two red buttons have
snapped out.
PUSH
9. Close the infuser door.
10. Put the water tank back.
DESCALING
Descale the appliance when the light on the control panel
ashes.
Important!
• Descaler contains acids which may irritate the skin and
eyes. It is vital to respect the manufacturer’s safety warn-
ings given on the descaler pack and the warnings relating
to the procedure to follow in the event of contact with the
skin and eyes.
Infuser
support
Small lever
Large lever