11
Please note :
If the appliance is not used for an extended period, place the
main switch (A8) in the 0 position (g. 3).
Important!
To avoid damaging the appliance, never place the main switch
(g. 3) in the 0 position until the appliance has been turned o
using the
button.
MENU SETTINGS
When you access the settings menu by pressing the P button,
the following menu items can be selected: Descale, Auto-o,
Set temperature, Energy saving, Water hardness, Install lter,
Replace lter, Default values, Statistics.
Descaling
For instructions on descaling, see page 15.
Auto-o
The time can be changed so that the appliance switches o after
being idle for 15 or 30 minutes, or after 1, 2 or 3 hours.
To reprogramme auto-o, proceed as follows:
1. Press the P button to enter the menu;
2. Turn the selection dial (g. 8) until the light comes
on;
3. Press the
button to select the function;
4. Turn the selection dial until the lights corresponding to the
number of hours before the appliance goes o automati-
cally come on:
15 minutes
30 minutes
1 hour
2 hours
3 hours
5. Press the button to conrm;
6. Press the
button to exit the menu.
Auto-o is programmed.
Setting the temperature
To modify the temperature of the water used to make the coee,
proceed as follows:
1. Press the P button to enter the menu;
2. Turn the selection dial until the light comes on;
3. Press the
button;
4. Turn the selection dial until the lights corresponding to the
required temperature come on:
LOW
MEDIUM
HIGH
5. Press the button to conrm;
6. Press the
button to exit the menu.
Energy saving
Use this function to enable or disable energy saving. When en-
abled, the function reduces energy consumption in compliance
with European regulations.
1. Press the P button to enter the menu;
2. Turn the selection dial until the E light comes on.
3. Press the
button. The OK light ashes.
4. Press the
button to enable or disable energy
saving mode;
5. Press the
button to exit the menu.
When the function is enabled, the E light remains on.
Please note :
When in energy saving mode, a few seconds may elapse before
the rst coee is delivered as the appliance must heat up again.
Setting water hardness
For instructions on setting water hardness, see page 16.
Install lter
For instructions on how to install the lter, see the section
“Water softener lter” (page 16).
Replacing the lter
For instructions on how to replace the lter, see the section
“Water softener lter” (page 16).
Default values (reset)
This resets all menu settings and programmed quantities back
to the default values.
1. Press the P button to enter the menu;
2. Turn the selection dial until the lights come on;
3. Press the
button. The OK light ashes;
5. Press the
button to conrm and exit.
Statistics function
This displays statistics relating to the machine. To display, pro-
ceed as follows:
1. Press the P button to enter the menu;
2. Turn the selection dial until the light comes on;
3. Press the
button;
4. When the selection dial is turned and the corresponding
light ashes, the following information is displayed:
-
how many coees have been made;
To Next Page
Loading...
Need help?
General
