4
S
D
B
C
Introduction
Congratulations on your purchase of this Delonghi gas cooker which has been carefully
designed and produced to give you many years of satisfactory use.
Before using this appliance it is essential that the following instructions are carefully read and
fully understood.
We would emphasise that the installation section must be fully complied with for your safety
to ensure that you obtain the maximum benefits from your appliance.
Fig. 1
Identification label
When you open the bottom oven
door the indentification label is at
the bottom right hand side.
This cooker has been designed, constructed and marketed in compliance with:
- safety requirements of EEC Directive “Gas” 90/396;
- safety requirements of EEC Directive “Low voltage” 73/23;
- protection requirements of EEC Directive “EMC” 89/336;
- requirements of EEC Directive 93/68.
Assembling the back-
guard
Before assembling remove any
protective film/adhesive tape.
The backguard B and the side
supports S and D can be found
packed in the drawer.
1. Insert the side supports S and D
into the backguard B (see fig. 1)
2. Insert the backguard group into
the support guides in the cooker
3. The backguard can be removed
for cleaning or fixed with a
screw through the hole C.
To Next Page
Loading...
Need help?
General