25
Conversion to LPG
1 -
Injectors replacement of top burners
To replace the injectors proceed as follows:
– Remove pan-supports and burners from the hobtop.
– By a spanner, remove the injector “J” (fig. 26) from its housing and replace it by the prop-
er one according to the kind of gas (see following “Table for the choice of the injectors”).
The burners are conceived in such a way so as not to require the regulation of the
primary air.
2 - Adjusting of the minimum of the top burners
Considering that in the minimum position the flame must have a length of about 4 mm and
must remain lit even with a quick turn from the maximum position to that of minimum.
The flame adjustment is done in the following way:
– Turn on the burner
– Tum the tap to the MINIMUM position
– Take off the knob
– With a small flat screwdriver turn the screw inside the tap rod to the correct regulation (fig.
27).
Normally for LPG, tighten up the regulation screw.
Fig. 27
J
Fig. 26
To Next Page
Loading...
