DeLonghi MAGNIFICA EVO - General Coffee Brewing Tips and Adjustments; Utilizing the Rinsing Function; Customizing Coffee Volume Per Cup

10
4. Select the required drink (B7);
5. Preparation begins and the Led corresponding to the se-
lection blinks on the control panel (B).
8.4 General indications for making coee-
based drinks
• Indicator lights may appear on the control panel (B) dur-
ing use. Their meaning is given in section “17. Explanation
of lights”.
• For hotter coee, see section “8.7 Tips for a hotter coee”.
• If the coee is delivered a drop at a time, too weak and
not creamy enough or too cold, read the tips in section
“18. Troubleshooting”.
• To customise the drinks according to personal taste, see
sections “8.5 Varying the intensity of the coee” and “8.9
Customising the quantity in the cup”.
Please note:
In energy saving mode, a few seconds may elapse before the
rst coee is delivered as the appliance must heat up again.
8.5 Varying the intensity of the coee
1. Press the button (B4)corresponding to the preferred
intensity:
Mild
Medium
Strong
2. Select the desired coee drink.
Please note:
• When the next coee is made, the machine will show the
last intensity setting selected.
• In the event of power failure, the machine will revert to
the default setting: medium.
8.6 Rinsing
Using this function, hot water can be delivered from the coee
spouts to clean and heat the internal circuit of the machine.
1. Place a container of at least 100ml capacity under the cof-
fee spouts (A16) (g. 5).
2. Press the button (B6) and hold for at least 5 seconds:
the cycle will start and stop automatically (to terminate
the cycle sooner, press this same button a second time).
Please note:
• If the appliance is not used for more than 3-4 days it is
highly advisable, when switching on again, to run 2/3
rinse cycles before preparing any drinks;
• It is normal for the grounds container (A10) to contain
water following a rinse cycle.
8.7 Tips for a hotter coee
To make a hotter coee, proceed as follows:
• run a rinse cycle (see section “8.6 Rinsing ”“);
• warm the cups with hot water, using the Hot Water
function;
• increase the coee temperature (see section “12. Settings
menu”).
8.8 Adjusting the coee grinder
The coee grinder does not require any adjustment, at least
initially, as it has been factory set to ensure that coee is pre-
pared correctly.
Please note:
The adjustment dial must be turned only when the cof-
fee grinder is in operation during the initial step of coee
preparation.
To make an adjustment while the coee grinder is in operation,
turn the dial (A2) as follows:
If the coee is delivered too
slowly, or not at all.
This adjustment will not take ef-
fect until at least 2 cups of coee
have been delivered.
Turn one click towards “7”
For a fuller bodied creamier
coee
This adjustment will not take ef-
fect until at least 2 cups of coee
have been delivered.
Turn one click towards “1”
8.9 Customising the quantity in the cup
1. Press the button relative to the drink being programmed
and hold for a few seconds: when the Led corresponding
to the selection blinks rapidly, the machine is in program-
ming mode. Delivery begins;
2. Once the cup is lled to the desired level, press the button
a second time. Delivery ceases and the quantity is stored
in the memory.
Please note:
To cancel the current setting, press a button corresponding to an -
other drink.
9. MAKING MILKBASED DRINKS
Please note:
• When using the carafe, check that all components are
clean and reassembled as indicated in the section “3.1
Prepare the milk carafe (E) for use” making certain that