11
11
44
44
11
11
55
55
9) Heating shutdown
- Stand-by mode
The thermostat is switched to stand-by mode in
periods when heating is not required.
Switch the selector to position .
The thermostat displays four
dashes.
10) A Problem?
11
11
88
88
6) Time setting
Turn the selector switch to the position.
Press or to adjust the
time.
The day changes after every 24 hours.
Pressing briefly : advances the time in minute
increments
Press and hold : Fast forward
Nota : When adjusting the hour, the heating is OFF.
11
11
33
33
7) Temperature settings
7.1 Setting the Frost-protection temperature
Default setting : 7 °C
➊ Turn the selector switch to
➋ Press or to adjust the temperature
(between 5 and 15 °C)
7.2 Setting the Economy temperature
Default setting : 16 °C
➊ Turn the selector switch to
➋ Press or to adjust the temperature
(between 5 and 15 °C)
7.3 Setting the Comfort temperature
Default setting : 19 °C
➊ Turn the selector switch to
➋ Press or to adjust the temperature
(between 5 and 15 °C)
7.4 Temperature display
Press the key.
The thermostat displays
four dashes.
11
11
77
77
8.2 Modifying and validating your program
Switch the selector to PROG
The temperature display disappears and
you can see the program for the first day.
The first time slot flashes.
Press for 1 hour of Comfort or for 1 hour of
Economy (The second time slot flashes))
Repeat the same procedure for each time slot.
Press immediately to validate and to access to the
following day.
Repeat the operations
➋
and
➌
for each day.
After programming, switch the selector on AUTO.
Note : For modes , and AUTO, the displayed
temperature is the temperature setting for the current time
period.
e.g. Day 3, it is 8.15 p.m.
The corresponding time period
blinks. The comfort temperature
is programmed, so its value is
displayed.
or Day 3, it is 4.20 a.m.
The Economy temperature
setting is displayed.
5) Fitting the batteries
Three 1.5 volt alkaline batteries of type LR03 or AAA
(last for more than 1 year).
Do not use rechargeable batteries.
To replace used batteries, remove the thermostat from
its base. Insert new batteries making sure that they are
fitted the right way round. Then replace the thermostat
on its base.
Battery replacement
When the battery replacement indicator appears,
the batteries in the thermostat are flat and must be
replaced. Never leave flat batteries in the device (the
warranty does not cover damage caused by leaking
batteries).
New batteries must be fitted within approx. 1 minute to
ensure that the programmed information is not lost.
11
11
22
22
11
11
66
66
8) Weekly programming
8.1 Define your weekly programming
You have 4 preset programs. You can select one of
them by turning the selector switch.
Permanent Frost
protection
(adjustable from 5 to 15 °C)
Permanent
Economy
(adjustable from 5 to 30 °C)
Permanent
Comfort
(adjustable from 5 to 30 °C)
At the first use,
Comfort from 6
a.m to 23 p.m for
each day of the
week.
You can modify this program.
4) Description
11
11
11
11
2700xxx Rév.1
Micro TYBOX H
RADIO X2D
Wireless week-day programmable
room thermostat
Bonnemain
35270 COMBOURG (France)
Tél. : 33 (0)2 99 73 45 17
Fax : 33 (0)2 99 73 44 87
http://www.deltadore.com
The symbol appears.
Nothing is displayed on the
screen.
The whole display is
blinking
Problem
• The batteries are discharged.
Replace the batteries (see p. 12)
• No power supply
- 230V mains model :
check the 230V power supply
- battery model :
replace the batteries or check
their polarities (direction)
The Micro-TYBOX has just been
switched on.
Check and if necessary adjust
the clock and the temperatures,
otherwise press a key.
Diagnosis / Solutions
To Previous Page
Loading...
Need help?
General
