Chapter 7 Servo Parameters|ASDA-A&A+ Series
7-56
Revision April 2009
P2 - 17
DI8 Digital Input Terminal 8 (DI8) Communication Addr.: 0211H
Default: 21 Related Section:
Applicable Control Mode: ALL Table 7.A
Unit: N/A
Range: 0 ~ 147
Settings: See P2-10 for explanation.
P2 - 18
DO1 Digital Output Terminal 1 (DO1) Communication Addr.: 0212H
Default: 101 Related Section:
Applicable Control Mode: ALL Table 7.B
Unit: N/A
Range: 0 ~ 112
Settings:
This parameter is used to determine the function and status of DO1.
not used
A
B
• A: DO Function Settings: For the setting value of
P2- 18 ~ P2-22, please refer to Table 7.A.
• B: DO Enabled Status Settings:
0: Normally closed (contact b)
1: Normally open (contact a)
Please re-start the servo drive after parameters have been changed.
P2 - 19
DO2 Digital Output Terminal 2 (DO2) Communication Addr.: 0213H
Default: 103 Related Section:
Applicable Control Mode: ALL Table 7.B
Unit: N/A
Range: 0 ~ 112
Settings: See P2-18 for explanation.
P2 - 20
DO3 Digital Output Terminal 3 (DO3) Communication Addr.: 0214H
Default: 109 Related Section:
Applicable Control Mode: ALL Table 7.B
Unit: N/A
Range: 0 ~ 112
Settings: See P2-18 for explanation.
Call 1(800)985-6929 for Sales
Call 1(800)985-6929 for Sales
To Next Page
Loading...
