Mechanical Installation
12
Proper mechanical installation of the
QuiQ charger is essential to its effective
operation.
ENVIRONMENT
Locate the charger with adequate
ventilation. Ideally, it will be
mounted horizontally with airflow
from below as per the arrows in the
illustration below. See Mounting Instructions
for more options.
The QuiQ Series charger case is an IP66
enclosure. It is well protected against
fine dust (IEC60529 IP6x), and capable of
operation in heavy seas, temporary flooding,
and heavy water streams (IEC60529 IPx6).
The input cord IEC60320 connector is rated
IP20 at this time. It is suitable for indoor use
only and must always be kept clean and dry.
Use of heat shrink over the mated connection
is strongly suggested for general use.
Delta-Q Technologies offers an AC cord that
will seal the connection to IP66. Contact
the manufacturer of your vehicle/machine
or the distributor of the charger for more
details. During charging, the surface of
the charger may become warm, especially
in higher ambient temperatures. This is
normal. Install so risk of human contact
with hot surfaces is reduced.
To Next Page
Loading...
Need help?
General
