Delta 11-990C - Final Assembly Steps; Install Clamp Handle; Mount and Secure Drill Press Head; Attach Pinion Shaft Handles

7
7. Figure 11, illustrates the table raising and lowering
handle (K) assembled to worm gear shaft (G).
8. Thread clamp handle (M) Fig. 12, into hole in rear of
table bracket, as shown.
9. Place the drill press head (N) Fig. 13, onto the
column as far as it will go. Align head to table and base
and tighten the two head locking screws (O) with wrench
supplied.
10. Thread the three pinion shaft handles (P) Fig. 14, into
the three tapped holes located in the pinion shaft, as
shown.
Fig. 11
Fig. 12
Fig. 13
Fig. 14
G
K
M
N
O
P