Need help?Do you have a question about the Delta 15'' scroll saw and is the answer not in the manual?
Secure the scroll saw to a workbench or stand using mounting holes or clamps.
Attach the table lock knob and washer to the designated hole for table adjustment.
Install the chip blower bracket, plug housing, and tube for dust removal.
Secure the switch toggle when the saw is not in use to prevent accidental operation.
Loosen the lock knob to tilt the table for angle sawing up to 45 degrees.
Turn the tension knob clockwise to increase tension and counterclockwise to decrease it.
Detailed steps for removing and installing pin-type scroll saw blades.
Procedure for performing inside cuts using pin-type blades through a drilled hole.
To Next Page
General
