Delta AS200 Series User Manual

Chapter 9 Ethernet Specification and Operation
9-105
9_
Item Description
Table name
To name your table, you can use up to 16 characters from the
following characters, A through Z (case-insensitive ), 0 through 9,
_ (underscore) , (comma) and . (dot) .
Device quantity
Device quantity to be monitored; default: read only
Default update cycle
Set up the updated cycle time; default: 5 seconds; unit: second
“Edit”
Click “Edit” to edit the table and the table name column turns
green. The table contents appear below.
“Delete”
Click “Delete” to delete the table and its contents.
Device
Devices to be monitored; you can enter the following devices to
monitor xX, yY, mM, sSmM, sSrR, dD, sS, tT, cC, hHcC and eE.
Radix
Positional numeral system to be shown on the monitoring page;
available formats are Signed decimal, Unsigned decimal,
Hexadecimal, Octal, Binary, 32bit Signed decimal, 32bit Unsigned
decimal, 32bit Hexadecimal, 32bit Octal, 32bit Binary, 32bit Float
and 64bit Double
Read only
Set up the monitored devices to read only or not.
Description
Add a description here for the table.
“Apply”
Click “Apply” to save the settings.
 Operation Steps:
a. After log in, double-click Data monitor setup to open the setting page.

Delta AS200 Series Specifications

General

Brand	Delta
Model	AS200 Series
Category	Control Unit
Language	English