Delta ASD-M-0721-F - Page 391

Chapter 8 Parameters ASDA-M
8-160 Revision December, 2014
P5-37■
CAAX
CAPTURE－Axis Position CNT
Address: 054AH
054BH
Parameter
Attribute：
Parameter for individual axis
Related Section:
Section 7.11.1
Operational
Interface：
Panel / Software Communication
Default：
0
Control
Mode：
ALL
Unit：
-
Range：
-2147483648 ~ +2147483647
Data Size：
32bit
Format：
DEC
Settings：
Shows the axis position of CAPTURE pulse source
NOTE
1) It is writable only when COMPARE stops (please refer to
P5-39)
2
) If the source is the main encoder, this parameter is
write-protected and the content is the feedback position of the
motor (monitor variable 00h).
P5-38■
CANO
CAPTURE－The Number of Capturing
Times
Address: 054CH
054DH
Parameter
Attribute：
Parameter for individual axis
Related Section:
Section 7.11.1
Operational
Interface：
Panel / Software Communication
Default：
1
Control
Mode：
ALL
Unit：
-
Range：
1 ~ (the value set by P5-10 minus the
value set by P5-36)
Data Size：
16bit
Format：
DEC