ASDA-M Chapter 8 Parameters
Revision December, 2014
8-161
Settings：
When CAP stops, it means the number of data that expect to
capture (readable and writable)
When CAP activates, it means the number of data that has not
been captured (read-only); Every time, when it captures one data,
the value of P5-38 will minus one. When the value is 0, it means
the capturing is completed.
NOTE
The number of data which is used by COMPARE, CAPTURE and
E-Cam cannot exceed 1500.
P5-39■
CACT
CAPTURE－Activate CAP Control
Address: 054EH
054FH
Parameter
Attribute：
Parameter for individual axis
Related Section:
Section 7.11.1
Operational
Interface：
Panel / Software Communication
Default：
0x2010
Control
Mode：
ALL
Unit：
-
Range：
0x0000 ~ 0xF13F
Data Size：
16bit
Format：
HEX
Settings：
X： See the following table
To Next Page
Loading...