Chapter 6 Control Mode of Operation ASDA-M
6-20 Revision December, 2014
The related parameters of auto vibration suppression:
P1-29
AVSM
Auto Low-frequency Vibration
Supression Setting
Address: 013AH
013BH
Parameter
Attribute
:
Parameter for individual axis
Related Section:
Section 6.2.9
Operational
Interface
:
Panel / Software Communication
Default:
0
Control
Mode
:
PT / PR
Unit:
-
Range:
0 ~ 1
Data Size:
16bit
Format:
DEC
Settings:
0: The function is disabled.
1: The value will set back to 0 after vibration suppression.
Description of Auto Mode Setting:
When the parameter is set to 1, it is in auto suppression. When
the vibration frequency is not being detected or the value of
searched frequency is stable, the parameter will set to 0 and save
the low-frequency vibration suppression to P1-25 automatically.
P1-30
VCL Low-frequency Vibration Detection
Address: 013CH
013DH
Parameter
Attribute
:
Parameter for individual axis
Related Section:
Section 6.2.9
Operational
Interface
:
Panel / Software Communication
Default:
500
Control
Mode
:
PT / PR
Unit:
Pulse
Range:
1 ~ 8000
Data Size:
16bit
Format:
DEC