Delta DVP-SS2

DVP-ES2/EX2/EC5/SS2/SA2/SX2/SE&TP Operation Manual - Programming
3-608
Example 1:
1. When M0 changes from OFF to ON, the INITC instruction starts to initialize the servos at
station addresses 1–3 (should be in a consecutive order), until M1615 is ON. (The station
address must start at 1 and the following addresses cannot be skipped or reserved.)
2. When M1 changes from OFF to ON, the ASDON instruction starts to enable the servo at
station address 2. When SM1641 is ON, it indicates Servo-ON.
3. When M2 changes from OFF to ON, the ASDON instruction starts to disable the servo at
station address 2. When SM1641 is OFF, it indicates Servo-OFF.