13
5. Align the holes in the longer section of rear guide rail
(P) Fig. 18, with holes (A), (B), and (C) in the saw table.
Place a M8.1 lockwasher then a M8.4 flat washer onto a
M8x1.25x16mm hex head screw. Insert the screw
through the hole (A) Fig. 18, in the rear guide rail. Place
a M8.4 flat washer and a M8.1 lockwasher onto the hex
head screw. Thread a M8x1.25 hex nut onto the hex
head screw. NOTE: TIGHTEN HARDWARE JUST
ENOUGH TO HOLD RAIL IN PLACE AT THIS TIME.
6. Place a M8.1 lockwasher and a M8.4 flat washer
onto a M8x1.25x16mm hex head screw. Insert the screw
through the holes (B) and (C) Fig. 18, in the rear guide rail
and thread into the tapped hole in the saw table. NOTE:
TIGHTEN HARDWARE JUST ENOUGH TO HOLD
RAIL IN PLACE AT THIS TIME.
7. Align the holes in the shorter section of rear guide rail
(R) Fig. 18, with holes (D) and (E) in the in the saw table.
Place a M8.1 lockwasher and a a M8.4 flat washer onto
a M8x1.25x16mm hex head screw. Insert the screw
through the hole (E) Fig. 18, in the rear guide rail. Place
a M8.4 flat washer and a M8.1 lockwasher onto the hex
head screw. Thread a M8x1.25 hex nut onto the hex
head screw. NOTE: TIGHTEN HARDWARE JUST
ENOUGH TO HOLD RAIL IN PLACE AT THIS TIME.
8. Place a M8.1 lockwasher and a M8.4 flat washer
onto a M8x1.25x16mm hex head screw. Insert the screw
through the hole (D) Fig. 18, in the rear guide rail and
thread into the tapped hole in the saw table. NOTE:
TIGHTEN HARDWARE JUST ENOUGH TO HOLD
RAIL IN PLACE AT THIS TIME.
9. Using a square (X) Fig. 19, or a ruler, adjust rail so
that it is 7/16" from top of the table along the entire
length. Tighten all mounting hardware.
Fig. 18
A
B
C
P
D
E
RIP FENCE
1. Insert handle (A) Fig. 20 into threaded hole (B) in rip
fence (C).
2. 2. Insert flat head screwdriver into rip fence handle
(A) Fig. 21 and tighten screw (not shown).
3. Tighten hex nut (D) Fig. 21 against fence body.
Fig. 19
X
R
Fig. 20
C
B
A
Fig. 21
D
A
To Next Page
Loading...
